Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

won't idle/run 200 1989

posted by  cat3 on  Fri Jun 10 11:05 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat May 1 09:23 CST 2010
[RELATED]

Help!

Have a 89 245 that will not idle and will run VERY rough if I pump the gas pedal and try to keep the rpm's up. The check engine light does not illuminate and there are no fault codes in the ecu. I unplugged the air mass meter and bingo, the car will now idle and run. I then checked the amm per the Bently manual and I read about 3.5 ohms between pins 2-3 which is in limits. I checked the ground and it's ok and then I checked for a voltage output at pin 3 of the amm. With the ignition on, I had 1.6 volts and it increases with airflow.

Before I start replacing parts, does anyone have any ideas? It "seems" that the amm is ok but I wonder if the ecu is bad? If the amm circuit in the ecu went bad, would the "limp home" mode still work?

Any ideas would be very much welcomed!

Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New won't idle/run [200][1989]
posted by  cat3  on Fri Jun 10 11:05 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.