Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1990 240 AC question 200 1990

posted by  nguyenmman on  Sat Jun 25 15:54 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello all,
The lo port on my compressor does nothing. I could not take a reading from it nor charge the system.
Is it possible that the port is bad and blocked. The hi port is OK. The sticker on under the hood says R-12, but the hi/lo ports are 134a type. The AC gives out cool air, not chill or cold. I can see bubble flowing thru in the glass window.
How much 134a will escape if I replace the lo port. If I want to verify the type of gas inside the system, which port I should take a reading so I can compare with the chart to see if it is r12 or r134a?
Is there time that someone put a new type of connector on the compressor but still use r12?
Last, how do I replace this lo port connector?
Thanks a lot,





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1990 240 AC question [200][1990]
posted by  nguyenmman  on Sat Jun 25 15:54 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.