Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2003 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What am I doing stupid with my fuel gauge 444-544

Due to some recent discussion of adding a resistor in line in order to use a 6 volt fuel gauge in a 12 volt car, I tried to bench test some of the pieces I have to figure out the best setup for my 445. I have 2 6 volt gauges, 1 12 volt, and a brand new sender bought from Volvo a few years back that reads about 20 ohms at empty and 190 ohms at full. The 6 volt gauges read about 50 ohms across the terminals if that means anything. I am using a cheapo battery charger as a power source 6 or 12 volts. The trouble is that no matter what combination of pieces I hook up, I get maybe no response initially and if I nudge the needle it will peg at full with some enthusiasm regardless of where the sender is set. I thought this would be pretty straightforward, can someone give me some help?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What am I doing stupid with my fuel gauge [444-544]
posted by  someone claiming to be Buz  on Thu Jun 30 14:39 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.