Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

cruise control information sought from any and all. 200

posted by  Patrick of Mtl on  Mon Jul 18 12:52 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 12 23:46 CST 2010
[RELATED]

I am adapting the volvo/dana/sears CC for a 68 220 with twin SUs. I need a vacuum point that is relativly constant, IE not behind the throttle plates, I am going to try using the out on the balancing tube of the intake manifold. But this is neither here nor there, I would like more info as to how volvo creates constant (relativly) vacuum.
The other ? is about the sensor on the 240. The sears set up uses a coil sensing a magnet attached to the drive shaft. WHere does the early volvo system sense speed? It comes with a coil type sensor, but has very short leads.
Any and all input welcome and appreciated.
--
--
Patrick, '68 220, '83 245, '92 Eurovan (work truck).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New cruise control information sought from any and all. [200]
posted by  Patrick of Mtl  on Mon Jul 18 12:52 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.