Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

m47 removal - do I need to rotate engine? 200 1989

posted by  Arthur on  Mon Aug 1 04:14 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 2 07:35 CST 2014
[RELATED]

just started the clutch replacement this morning. While I wait for blaster to work on shifter setscrew I have question.

I found one reference in forums to removing an engine mount to allow the engine to rotate to clear the starter motor bulge on bellhousing from body. Do I need to do this? i've got the engine supported from rear hanger. I don't think it will move much like this. I cannot get upper starter bolt out of its hole-it hits the body.

Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New m47 removal - do I need to rotate engine? [200][1989]
posted by  Arthur  on Mon Aug 1 04:14 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.