Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Cruise control connections 200 1991

posted by  Five Bricks on  Wed Aug 3 08:21 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 22 15:09 CST 2007
[RELATED]

I installed a cruise control setup on our '91 244. It engages, but the speed gradually decays. The system doesn't seem to compensate for engine speed for engine speed changes.

There don't seem to be any vacuum leaks, and the I know the vacuum pump is functioning to a at least a certain degree. I have two questions.

- The front of the pump has two nipples, one black and one white. The vacuum line to the passenger compartment connects to the black nipple. On the donor car, there was nothing connected to the white nipple. Is it just an air inlet, or should another hose be attached?

- Do I need to pull the instrument cluster and connect some wire to the speedometer, or doers this connection come "standard"? The there was an unused fitting under the dash for one connectors on the little cruise control harness. I just plugged in and assumed the instrument cluster connection was in place.

Naturally, I am open to any other troubleshooting suggestions! Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cruise control connections [200][1991]
posted by  Five Bricks  on Wed Aug 3 08:21 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.