Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

can someone outline the procedure for setting the fuel mixture? 200 1984

posted by  88 760GLE on  Fri Aug 5 01:54 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

i imagine this is something that would be in a bentley manual, but i can't afford one right now. i think its also referred to as "setting the base idle mixture."

i had been reading a steady voltage off my O2 sensor (0.80 volts), troubleshooting confirmed its functionality though. i decided to screw around with the adjustment on the AMM (very difficult to turn) and suddenly the voltage off the O2 sensor started fluctuating like i would normally expect it to. now it jumps around between ~0.35 and ~0.75, apparently someone had set it to the max rich setting...

i know on the 700 there is a procedure outlined in the faq section, but i don't have those test connectors on my jetronic setup, since its an 84 b23f i think i have LH 2.0, but i'm not sure.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New can someone outline the procedure for setting the fuel mixture? [200][1984]
posted by  88 760GLE  on Fri Aug 5 01:54 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.