Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2013 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

alternate oil temp sender location? 200 1988

posted by  michelg on  Sat Aug 20 17:59 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Nov 23 05:14 CST 2007
[RELATED]

I'm planning on installing an oil temp gauge in my 240. I know that the typical location is to replace the drain plug in the oil pan. I was planning on having a bushing welded into the oil pan and installing the generic sender from egauges.com into that.

However, I'm wondering if it would be possible to take a reading directly from the oil gallery.

In this pic (from a turbo motor, not mine) there's a blue fitting installed where there's normally a plug in the block.



My questions: does this in fact go to the oil gallery, would I have enough clearance for the sender (I'm guessing probably), and would it give me a good oil temp reading?

BTW, the other motive for this is to leave the oil pan intact :-).

Michel

1979 242DL
1988 244DL





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New alternate oil temp sender location? [200][1988]
posted by  michelg  on Sat Aug 20 17:59 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.