Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

D24T Diesel Loose Pre Chambers 700

posted by  werick on  Fri Aug 26 15:23 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 6 08:25 CST 2011
[RELATED]

Hi All:

I just purchased a D24T Cylinder Head complete. I haven't sent it out for cleaning and inspection yet. The PO assured me it came from a running car.

I'm concerned about 2 loose pre chambers. They don't appear to be damaged. And push back in snugly. They still have their locaters. And fit flush with the head surface. How snug are these chambers supposed to fit? How can I tighten them up if you think they are too loose. I'm concerned they might work loose in operation.

A fellow on another board said he had one of these come loose and wind up in the cylinder. I really can't see this happening. Especially The way it's held in by the Head Gasket. Unless it broke into pieces.

Thanks again






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New D24T Diesel Loose Pre Chambers [700]
posted by  werick  on Fri Aug 26 15:23 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.