Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2013 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Value help- '68 144 140-160

uid 779's pic
posted by  matt b on  Thu Oct 16 04:42 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 14 16:33 CST 2014
[RELATED]

is that to say rear transmission seal? If so, it ain't so hard. They don't leak that badly though even if the seal is bad.. *unless* the output shaft bearing is shot. Then again though... the output shaft bearing isn't too tough either. Both can be done at the same time.. trickiest part will be pulling the driveshaft flange. Then a simple matter of pulling the bearing housing as I recall... No need to remove the transmission.

--
-Matt I ♥ my ♂






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Value help- '68 144 [140-160]
posted by  Swdspd  on Mon Oct 6 08:27 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.