Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

installing water pump--heater connector resisting 200 1982

posted by  Volvo From Heck on  Wed Dec 31 18:00 CST 1969
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 20:56 CST 2014
[RELATED]

I'm glad you have the problem licked Bob.  I've never seen a B23 with lambda sond.  They may have used such a system on more stringent California bound cars.  As long as you installed the seal on the pipe before it entered the WP there should be no problem with sealing.  So now I'm curious, because the E version has a higher compression ratio than we see south of the border--what kind of  HP/torque rating, and at what rpm does it get listed at? . --  Dave 





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New installing water pump--heater connector resisting [200][1982]
posted by  muskox37  on Fri Mar 13 15:51 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.