Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to replace 93 240 ignition switch 200 1993

posted by  1pocket on  Thu Mar 19 14:53 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

having done 3 of them all the advice given is sound.

to add one last bit the real problem is access because of the thick wire harness that lays over the top of the switch greatly obscuring access and visibility.

remove cluster but first disconnect neg bat terminal
use a pry bar of long screw driver and lift the harness that lays over the switch up as much as you can. be careful since the srs wiring to the clock spring is in this spaghetti. if you move the harness up so you can see the job goes fairly quick and easy from below look upwards






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to replace 93 240 ignition switch [200][1993]
posted by  woodshavings  on Wed Mar 18 12:01 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.