Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Head Pipe 200 1993

posted by  someone claiming to be flaccidio on  Fri Apr 26 11:43 CST 2002 [RELATED]

can't you get one from a junk yard, or take off the 'tack welded' heat shield and repair the rustedf area??

sounds a lot less expensive to me :)

i would also call around to see how much you can get the exhaust header for on your own. I'd say about $175US, plus another $15 for new studs and Copper lock nuts, and a manifold gasket and cat donut. Add $15 shipping and you can DIY (easy job) for a total of $205. For an additonal $100, FCP Groton will send you all the rest of the exhaust aft of the CAT with hangars and clamps. Notwithstanding a broken stud on the manifold to exhaust header flange, the replacement should not take over 1 hr tops. Be sure to PB blaster the nuts several times in the hour before you attempt this.

just did mine..easy

good luck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Head Pipe [200][1993]
posted by  someone claiming to be Mike from Sacramento  on Thu Apr 25 12:54 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.