Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Control arm bushing replacement. 200

posted by  unggthat on  Mon Oct 14 06:30 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Mar 6 10:37 CST 2014
[RELATED]

well, I did it...but its not that pretty. The rear ones you can do with a vise and some good pipes of the right size, but the front ones can be quite a bit harder....we ended up using a welder to heat them up and hammer them out..but you could take out the rubber, cut through the bushing, and then hammer it out...install with a vise or something....takes longer, but do-able. good luck
nate gundy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Control arm bushing replacement. [200]
posted by  someone claiming to be Jim Hampton  on Mon Oct 14 06:21 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.