Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

REPLACING SWAY BAR END LINK GROMMETS

posted by  JohnB@MAC on  Tue Oct 15 08:29 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Dec 9 10:15 CST 2007
[RELATED]

I would suspect you'd have to jack up the car, remove the wheel(s) and then go to it. You may have to replace the entire link, IIRC the link eliminated the serviceable bushing (well, it wasn't that serviceable, had to be pressed out and a new one pressed in) and only the link is sold today. Volvo calls them anti-roll bar end links.

The grommets (the grommet stack, if you will) are compressed to a length of 42mm measured from the outer edge of the washers.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New REPLACING SWAY BAR END LINK GROMMETS
posted by  someone claiming to be '92 940T  on Tue Oct 15 07:41 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.