Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Over drive controll 700 1992

posted by  ckbrew on  Sun Mar 23 03:20 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Dec 7 22:20 CST 2012
[RELATED]

The over drive controll system on my 745t Is not functioning. The car is in OD all the time, but pushing the cut out switch will not disengage the OD. I replaced the OD solenoid. That did not solve the problem. In the process of replacing the solenoid, I was first given an incorrect solenoid. When that solenoid was installed, then OD was cut out, and would not engage. The OD indicator light was on. When I run the car without any solenoid, the OD is disengaged, and the OD indicator light is off. So the mechanism controlling the trans works, & the solenoid is new. Must be the switch in the shifter, correct? How should I check for this? How shoud I go about opening up the shifter & replacing the switch? Or is there something else I should do?
Thanks.
Mark- 1992 745T 207K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Over drive controll [700][1992]
posted by  ckbrew  on Sun Mar 23 03:20 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.