Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

yes, there is a hp switch. 700 1986

When you say to fill until the low side is 30psi with the compressor running, is this at idle or at 2000rpm? Also, what should the outside temperature be?

Either I have a leak or there is a boat load of freon in there. I suspect the fitting for the orifice valve because there is a wet-looking grime on the connection. There should be leak detector dye in the system. I think that it is activted by UV light? I actually have a hand-held UV light at work that I could borrow. Perphaps I could try it.

When I fill the low side, some yellow-green foam comes out when I disconnect the fitting. The foam then mostly goes away, but not completely. Is this the freon or oil and is it normal?

Thank you!
Steve






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Is there a way to adjust the heater valve? [700][1986]
posted by  SLong  on Tue Jun 3 03:04 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.