Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 Performance Alignment 200

posted by  someone claiming to be Rhys on  Mon Jun 30 15:01 CST 2003 [RELATED]

I would advise the regular toe-in setting of about 1/16 inch. For camber, go slightly negative, perhaps as much as 1/2 degree. Get as much caster as can be achieved. A good shop will use the play around the ball joint plates to adjust caster, which is not considered adjustable by Volvo.
I believe the camber will go positive as you lower the car, but I am not sure. The two slots on the top of the strut do adjust camber. Keep in mind that as camber is adjusted, toe will also vary (toe being set last of course).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Performance Alignment [200]
posted by  someone claiming to be dschwied  on Mon Jun 30 13:12 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.