Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2009 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Floor pan 120-130

posted by  walrus3 on  Thu Aug 14 16:04 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

If you are familiar with working sheet metal and welding it, it is not
too hard. If you have holes and the outer edges are still good it might
be easier to weld in patches. Be sure the metal you use is thick enough.
I used 16 gauge but 18 or 20 might be OK. Don't go any lighter than that.
If you have started wearing bifocals since you last did a lot of welding,
you are in for a steep learning curve and probably a LOT of sore muscles.
--
George Downs, The "original" Walrus3, Bartlesville, Oklahoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Floor pan [120-130]
posted by  ovlov  on Thu Aug 14 14:02 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.