Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

broken crank position sensor bracket - fix? 200 1989

posted by  Arthur on  Thu Dec 30 05:42 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 2 07:35 CST 2014
[RELATED]

The wire on the sensor was rotted, and also intermittent no start, so I go to replace it. The sensor was frozen in the mounting bracket and it didn't take much to break the bracket. One side on the casting was very thin (< 1 mm). Maybe a defect?

So now what is the fix? I have another bracket on an old engine, but it looks like I have to remove the bell housing to get at the bolts. Is there another way?

Very unhappy camper today.

As always, thanks in advance. The advice here can't be beat.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New broken crank position sensor bracket - fix? [200][1989]
posted by  Arthur  on Thu Dec 30 05:42 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.