Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2020 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

machining an arn wheel 120-130

posted by  JohnMc on  Tue Jan 25 01:10 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 07:42 CST 2014
[RELATED]

In my case - just took off the obvious. The back edge of the flywheel - from the outer edge forward to the ring gear, and inward until close to the pressure plate bolt holes. Didn't take anything else off - left the clutch surface full thickness. This metal was both 100% non structural and at the rim - where it makes the most difference.
--
I'm JohnMc, and I approved this message.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Alloy flywheel [120-130]
posted by  someone claiming to be 122 owner  on Sat Jan 22 13:58 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.