Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Found the engine problem - not a broken rod 200

posted by  bosozoku on  Thu Jun 2 01:43 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Feb 16 14:31 CST 2007
[RELATED]

Thanks, all, for the advice.

The valve did not hit the piston to my knowledge - there looks to be no damage to either the valve head or piston.

All of the vacuum lines have been done within the last year, as have the water pump and the 'stat. I'll clean out the oil seperator before I put everything together. As far as surfacing the head, that sounds expensive and prone to problems. If I stick the head on a glass sheet and check for warpage with a feeler gauge, and find that the head is within spec, can I get away with not surfacing?

Thanks,
-b.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Found the engine problem - not a broken rod [200]
posted by  bosozoku  on Wed Jun 1 14:14 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.