Well, TR Conn was kind enough to send me his unused Volvo hydraulic clutch setup. His only stipulation was that I make it work and post it here.
My car is a 1983 245 Turbo with a 5.0/T5.

So I haven't had time to do more than look yet. I can see that the Master cyl will fit on my fire wall. I goes in a little lower than the cable hole. But I see a block off plate with a vacuum line coming through it where this thing will fit perfectly. The only problem I see in this area is all the Wire Harness running around but I have been wantoing to clean up the look in this spot anyway.
As far as under car goes. I should have lots of room to mount the slave cylinder. I just need to figure the mount and see if there is enough throw in the stock system.

I will take pictures once things are happening. And keep a list of parts I use.

Please forward any advice.

thanks
george