Volvo AWD V70-XC70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2007 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

In trouble after replacing plugs V70-XC70

posted by  e21Pilot on  Sat Dec 2 19:49 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Sep 27 01:59 CST 2014
[RELATED]

I replaced the plugs in the 2000 V70XC with the standard Bosch copper ones from IPD.

When I first got the cover off, I noticed there was a little oil in the head area so I cleaned up with a little degreaser and water. Other than that, everything went smoothly.

I started up fine but after about a minute I noticed that the engine started to miss and run rough. It's continued to do so and the Check Engine light came on as well. I suspect the missing plug is causing too much gas to enter the catalytic converter so I shut off the engine.

I checked my work and everything seems fine. I don't know how to tell which cylinder is not firing? I have a volt meter and a timing light but I'm not sure where to hook it up.

Any suggestions on how to test the ignition system?

Thanks,

RGW





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New In trouble after replacing plugs [V70-XC70]
posted by  e21Pilot  on Sat Dec 2 19:49 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.