Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2022 850 INDEX

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't remove from license plate frame 850

I know this is stupid question but I can not get our front license plate frame off. It acts like the screws are stripped. I even tried to pull and turn at the same time and still no luck.

Anyone know anything about this? Thanks in advance.








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't remove from license plate frame 850

it is not a stupid question.it happens.the way the frame is secured in the
bumper is through a plastic piece that snaps into the bumper (hole in the bumper)then the screw screws into it.the piece in your case is turning inside the hole which is not supposed to.i think that you should just pull harder on the frame and it should come out with the snaps. i think you should be able to get new ones from dealer or junck yard or apply some tough glew to the one you
have after taking out the screws and put them back it should prevent them from spinning.good luck








  REPLY TO THIS MESSAGE    PRINT   SAVE 

Can't remove from license plate frame 850

Thanks I will try that next weekend.

Hawkeye







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.