|
Hello, This is not for the faint of heart. Most of the time I can pry on the front side of the plastic lock where the small piece of the release is, but it does get broken inside the lock enclosure cover. The rear tailgate is even worse. First, recline seat all the way down and lower to its lowest position. second, remove plastic collar for door handle, remove small bueaty panel and remove the torx 25 screw, carefully pry up the door switch, don't disconnect yet. third, remove black window corner panel then lower window, pull up on door panel edge, you might need to use some force. after panel is loose from top of door there is a triangle piece of black plastic that needs to be removed. Now you can see the door latch,roll the window back up, at the bottom right is the main part of the lock, try releasing all lock parts by hand inside the door. if that doesn't work the lower part of the door lock needs to be broken in order to release the door. I would like to punch the designer of that POS! Make sure you have a replacement handy. If I were you and have never done one I would practice on one from a junk yard with door panel allready removed and door shut. Good luck.
|
