Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2013

[<<]  [>>]


THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD




  REPLY TO THIS MESSAGE    PRINT   SAVE 

water pump gasket

In the middle of timing belt/water pump job. So far the hardest part is that the WP gasket came out of the box a little bent so it wont sit flat on the locating pins on the block. I am afraid that when i place the pump, I am going to shift the gasket.

Any tricks, like a little glue/cement on the pump and put on the pump first?








  •   REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

    water pump gasket

    Never on the block, just the pump. Read the thread:

    http://www.brickboard.com/AWD/volvo/1259708/850/water_pump_gasket.html

    Rule308 is a real live mechanic in Los Angeles with about 30+ years of Volvo work.








    •   REPLY TO THIS MESSAGE    PRINT   SAVE 

      water pump gasket

      I used a super thin smear of pipe dope. I hope it is OK.
      Pain in the ASS. The hardest part of the job. Mostly because i know if the gasket doesn't sit right the thing will leak. It always comes down to the cheapest part.







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.