Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2024 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Any suggestions on how to secure heat insulation by exhaust manifold? 850 2016

posted by  someone claiming to be Hugh on  Tue Jul 19 19:41 CST 2022 [RELATED]

Hello All,

I have a 1996 850 GLT wagon (5 speed manual with 433,000 miles). There is an aluminium clad heat shield material that is attached to the firewall that is adjacent or just opposite the exhaust manifold/flex pipe. This heat shield has torn/separated and now rests gently against the exhaust manifold/flex pipe. I have tried taping it back into place and have tired gluing it back into place to no avail. Each time, due to the excessive engine heat I suspect, the heat shield comes loose and falls against the exhaust manifold/flex pipe. It doesn't hurt the engine, cause noise, or affect the driveability of my 850. However, esthetically, it bothers me. I suspect I am not the only person with an old 850 suffering this dilemma, so I would welcome any suggestions of how I could go about securing this heat shield so it stays in place. Thank you to all who respond.

Hugh






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Any suggestions on how to secure heat insulation by exhaust manifold? [850][2016]
posted by  someone claiming to be Hugh  on Tue Jul 19 19:41 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.