Hallo, i own a 440 volvo 1992 model with B18FP engine.I am looking to getting more power from the engine.I have heard about porting the cylinder head and fitting larger valves along with a reground camshaft.Could these do the trick and what power gains would i see?Would i have to reprogram the ecu and change the injectors?What about the throttle body?I have so many questions and so few answers.I really hope someone can help me.Thanks.

I wouldn't do too much on them.

The engines are based on Renault but Volvo changed them in every detail, they hired Porsche R&D people to do some finer exhaust manifold, piston and head modifications. The engines are above average, but not as good as a Swedish B23 or one of those..
The engine is not the problem.

Biggest problem is the transmission, they are unmodified Renault trannies that have their bearings shot between 200.000 and 230.000 km. At least, all of the 4 Volvo 440's i know, wrecked their tranny between those km's.

I have a red 1995 440 turbodiesel, i like the engine, it's competitive to petrol cars i meet at the streets, and it does a fine job pulling trailers.
I also like the coachwork and wheel suspension, as it has about 5 cm more ground clearance than average. I live around the forest, and in bumpy dirt roads, nothing beats the Volvo, for the ground clearance and because the long and smooth springs keep a good contact with the bumpy road.
I can climb hills with it, when every upwards meter is about 2 forward meters. Just incredible.

But the biggest problem is the tranny, i bought a tranny from a wreckyard, it was a bad one and i changed it within warranty. Now i have the second tranny from the wreckyard, but this one also has a shot bearing. My 440 is in the barn, tomorrow i will unmount the tranny and have all bearings and synchromesh rings changed at a professional overhaul shop.

You can expect tranny overhauls every 30.000 km if you want to tune it to 170 hp, and use 100% of the horses every day. An ordinary driver will do 200.000 km with it driving carefully. What will happen when you RACE at 150% of the power ??

By the way, did you know that Renault racers tend to use the heavier Volvo clutches, crankshafts and manifolds ?? Dont search for Renault parts, as Renault racers search for Volvo parts. They wont just do that without a reason....

first of all use dual camshaft cylinder head. second, install turbo. third, special ECU (www.magnetimarelli.com) after that, notice your gearbox not good. etc.etc.good luck.
--
i prefer non-german cars

What you need is an engine tuner/builder. Probably easiest to locate a Renault engine tuner as the 440 uses renault-based engine.

This is an expensive and labour-intensive process though.

To get any significant power gains you would need to remove the cylinder head from the engine, have larger valves fitted, ports cleaned up and opened up further.

Then select a 'wilder' camshaft with bigger lift and longer duration.

Throw away the normal intake plenum and throttle body and fit 4 separate throttle bodies to the engine with correctly spaced intake 'trumpets'. (going to be very difficult on this engine though.. litte space.. so may need to limit the camshaft to a 'mild' type that will work on a plenum and single throttle body setup)

Add a new exhaust manifold (4-2-1 style) with tuned lenghth primary and secondary pipes for maximum torque gain.

If you want to increase the rpm limit on the engine then make sure your pistons, connecting rods and crankshaft are up to the job. You may need to change to forged pistons and connecting rods and perhaps a steel crank... Engine builder should know about that.

With new pistons you can also bump the compression ratio up a little to somewhere around the 10.5 to 11:1 mark.

Then ditch the normal ECU and install a programmable ECU and have it mapped on a rolling road.

My guess is that would potentially give you an engine capable of pushing 160 to 170 bhp. Depening on how good the head flows it may be even more. You will need to rev the balls off of it though to get all the power...

But.. It's gonna cost 'ya to build it and it will become more maintenance intensive and damage-prone.

Bye, Arno.