Volvo AWD V70-XC70 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2008 V70-XC70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bilstein TC strut V70-XC70

posted by  gwoodall on  Thu Apr 27 03:02 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 12 19:46 CST 2011
[RELATED]

I have noticed that there is a gap between the cap (the large round part that covers the top of the strut mount just below the top bolt) and the strut mount of about 1/4". I have everyting tight and there are no noises now that I have replaced a sway bar link. Rides great.

I don't think there was a gap before I replaced the original struts with the TC's. My guess is the cap, which is surrounded with rubber, is to seal the strut mount bearing from moisture and dirt. I did replace the seats with febi/bilsteins but not the mounts. Am I mistaken about this gap? Any thoughts from those who have installed TC's. Is it possible the threads on the piston don't go down far enough on the TC's?

Thanks to all
gene
V70 2000






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bilstein TC strut [V70-XC70]
posted by  gwoodall  on Thu Apr 27 03:02 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.