Volvo AWD S80 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2016 S80 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Pressure for Flushing Brake System w/ABS S80

posted by  someone claiming to be long-gone on  Wed Sep 16 02:33 CST 2009 [RELATED]

I've seen it stated that flushing the brake fluid in a car with ABS requires up to 30psi of pressure. The procedure on alldata.com calls for between 29 and 43 psi. I've always thought that pressure any higher than about 15psi can pop the reservoir off the master cylinder.

Which is correct, 15 or 30+ psi??

The alldata procedure also calls for the bleed to start at the left front wheel (closest). Again, I've always started with the right rear (furthest).

Is this an ABS thing? Should I really start with the front left?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Pressure for Flushing Brake System w/ABS [S80]
posted by  someone claiming to be long-gone  on Wed Sep 16 02:33 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.