Volvo AWD S70 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 S70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Put the head back on S70 1998

posted by  KlausC on  Wed Feb 10 09:38 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

Great! Before you put on the cam position sensor, clean it real good and make sure the CPS wires don't go across any plug wires. If you have a short section of vacuum line(used), cut it lengthwise and use it as a cover for the CPS wires. Vacuum lines work great for the fuel injector wires also.

Rotate the engine 2 times, 720 degrees, by hand before you put the plugs in.

After you start the car, leave it running for at least 5 minutes. You want the oil to circulate completely and get the air out of the passageways.

Buy some beer and relax for a while :)

Klaus
--
Proud owner of a 220S. If I had more room, I would have more Volvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Liquid gasket for twin cam heads [S70][1998]
posted by  David Samuels subscriber  on Mon Feb 8 14:48 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.