Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

96 850 GLT OEM Upper Torque Bushing Installation 850 1996

posted by  joe pulkowski on  Tue Oct 22 17:47 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 27 07:53 CST 2013
[RELATED]

I'm planning on installing a new OEM bushing this weekend. I have the new bushing.

I was going to cut/hacksaw out the old bushing.

To install the new one, I have a stack of of large grade 8 washers, 7/8", 5/8", 1/2" that I tack welded together for the pressing of the bushing. On the opposite side of the bracket, I have an ABS coupling, and a piece of 1/4 x 3 x 3 Aluminum, drilled in the center for a 3/8 threaded rod. Using the rod, I was going to drive it in.

I experimented with freezing the bushing and compared the dimensions at room temperature, and maybe its slightly less, fractions of a millimeter. The bushing measures approx 60mm.

Any tips on installation?

Does a lubricant help? i was thinking a dry lube like graphite, vs WD 40.

Should the arrow on the bushing point up on the driver side?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 96 850 GLT OEM Upper Torque Bushing Installation [850][1996]
posted by  joe pulkowski  on Tue Oct 22 17:47 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.