Volvo AWD S70 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2019 S70 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

P0410 still failing after replacing pump and valve. S70

posted by  flwright64 on  Mon Apr 7 12:43 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 14 22:16 CST 2014
[RELATED]

I have to say the replacement pump and valve were marked "made in China", so I'm not entirely sure I put good parts on. But, the pump noise happens normally as far as I can tell.

Cleared the CEL fault. At first, I was able to go a couple of days before CEL light. Now, it's pretty much next day and the code returns.

The pump was installed before I could replace the valve (had to order the gasket separately). my real-time ODB2 reader shows a status of "UPS" on SAS then OFF.

Replaced the primary O2 sensor a couple of years ago. But, my second O2 sensor has been flatlined for years.

How do I diagnose this?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New P0410 still failing after replacing pump and valve. [S70]
posted by  flwright64  on Mon Apr 7 12:43 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.