Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

New serp belt

2000 V70 SE, N/A, Denso, AW55-SN, 261K miles

Having a heck of a time getting a new serpentine belt to go on. It's a new Volvo belt, p/n 2458376.

The tensioner is the "new" style with the torx receptacle and I have a long bar with the torx head on the end to fit. The old belt came off O.K. (this is a 60K service replacement).

At full travel-release of the tensioner, the new belt won't slip over the tensioner roller. Basically the belt is too short or it seems that way. A new belt will be tight of course, but I'm lacking about 1/2" - 3/4" for the belt to clear the roller and slip over. Just to make sure I'm doing it correctly, I reinstalled the old belt - no problem - it slipped right on.

I don't really want to pry or force the new belt. Any tricks or methods out there? Warm it up in the sun? (Works for mounting stubborn motorcycle tires).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New New serp belt
posted by  Robert S. subscriber  on Tue Jun 18 12:16 CST 2019 >
  • New New serp belt
    posted by  Chris Mullet subscriber  on Tue Jun 18 17:37 CST 2019 >
  • New New serp belt
    posted by  KlausC subscriber  on Wed Jun 19 09:09 CST 2019 >
    • New New serp belt
      posted by  Robert S. subscriber  on Wed Jun 19 16:54 CST 2019 >
  • New 1 New serp belt
    posted by  Robert S. subscriber  on Sun Jun 23 11:06 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.