Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2014 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

oxygen sensor bench test advice 850 1994

Just removed my o2 sensor today and bench tested it. Need some advice on the results. When applying heat with the propane torch to the tip (red hot) I get a maximum of .8 volts from the sensor. When I remove the torch the voltage drops to .1 volts in about 8 seconds. Too slow ? re applying the torch the voltage goes to a maximum of .8 volts again in 8 seconds. Too slow ? the faults I was getting on A2 socket were 435 and 436 (slow response).

Tried cleaning the sensor but didn't seem to make a difference. The car still idles rough and sometimes seems to be hunting for correct idle speed.

I need advice before paying big bucks for new sensor.

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New oxygen sensor bench test advice [850][1994]
posted by  someone claiming to be chuck  on Sat Dec 7 16:49 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.