Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front Wheel Bearing Replacement 850 1996

posted by  georgep on  Fri May 16 16:21 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I am planning to replace the left front wheel bearing hub assembly on my 96 850 (80K).
In reviewing the Haynes manual on this job, the installation instructions say to "apply .12 to.16 inch of metal adhesive to the splines of the outer CV joint before installing the joint into the hub flange." My question is what type of metal adhesive is required? Can this metal adhesive be bought at a parts store or is a dealer the only source of this metal adhesive?

Also the instructions in the Haynes manual says that after torquing the bolts that hold the hub to the steering knuckle, to use an "angle tightening gauge."
My next question is, what is an"angle tightening gauge" and is it possible to do this part of the job without an agle tightening gauge?
Thanks in advance for any help someone can give me with these wheel bearing replacement questions.
GP






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front Wheel Bearing Replacement [850][1996]
posted by  georgep  on Fri May 16 16:21 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.