Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2001 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Lower Control Arms 850 1994

posted by  Griff89 on  Sun Jun 6 14:02 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello,
This weekend I will be doing front brakes on my 850. Car was at Swedish Engineering a few weeks back and I was told passenger side ball joint was beginning to go.I have a new IPD A-arm but intend to do brakes first and then replace a-arms with in the next few weeks. I have the following questions.
1. Shouldn't both a-arms be replaced while I am an it.
2. Do discs and rotors need to be removed to get to ball joint? Looks like enough room is there to lave them on.
3. Haynes manual says to torques everything after car is down and suspension is loaded. How are mounting bolts reached and manual also says an angle gauage is needed? What gauge they referring too?
4. Any special tools or items I need for this job?
This is the first car I've owned that ball joint is integral to the a-arm so please excuse my lack of knowledge in this case.
Thanks!
Joel






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Lower Control Arms [850][1994]
posted by  Griff89  on Sun Jun 6 14:02 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.