The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Heater Hose Fitting 850

posted by  someone claiming to be ksg on  Mon Sep 18 09:26 CST 2006 [RELATED]

No special tool. The clips which look green or yellow have 2 tabs which are squeezed together with a small channel-lok or similar pliers until the barbs will pass by the groove inside the bulkhead connector which normally retains them against pulling out. Usually you can get one side free then wiggle the hose lots and in the end the other will come free. The overall fit is tight and it took me lots of steady pulling to get them to free up. Even with the barbs past the groove the fit is tight due to sealing rings.

Please pay attention to the order of the rings and spacers and also notice that one or more may remain inside the connector rather than coming out with the hose.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.