The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

s70 glt crankshaft pulley S70

posted by  someone claiming to be winchester54947 on  Fri Jan 25 11:50 CST 2008 [RELATED]

I purchased a 98, with 128K and am replacing 7 year old timing belt with 60K on it, along with water pump, idler and tensioner rollers, just so I can avoid a catastophic engine destruction and get some sleep .
I had to loosen the crankshaft pulley 1/4" to get the old belt out from behind the casting or spacer with the rubber ring on it behind the bottom of the pulley. I had to remove the pulley to remove the rear timing cover to clean off the waterpump gasket. Whoops !@#$? no !@#$ keyway. The pulley seems to only go back on in one position. Are the splines keyed in some way? Is the notch on top of the pulley tooth (sure looks like two adjacent teeth each have the notch?) aligned to the pointer mark on the block at TDC of cylinder #? if I need to verify correct position?






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.