The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Brake Caliper Pins V70-XC70 2001

Today was a little warm for this time of year (50-some degrees F) so I decided to
change the brake pads in my V70T5. The job went VERY easily until I got to the last wheel,
which happened to be the right front. This is the one that had a balljoint failure
several months ago.
I had one pin (the upper one) that did not want to come out with the 7mm Alum wrench.
I rapped on the long handle with a heavy screwdriver handle but it did not break loose.
I put a bit of P'Blaster on it when I noticed the hex in the end of the pin was getting
wallowed out. I came back after a bit and held the alum wrench in the pin and smacked
it a couple times with a 3# hammer, which (MANY thanks!) broke it loose, so I
was able to finish the job.
Is this a common problem with these? Seems like the pin must be pretty soft!
I'll get a new pin for it next time I am in Tulsa. Meanwhile I didn't tighten it TOO tight.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.