The message to which you are about to reply is shown first. GO TO REPLY FORM
posted by
someone claiming to be Alastair
on
Fri Jun 4 07:28 CST 2004 [ RELATED]
|
|
This is a doddle....
Remove the cold air intake to the air filter first (just clips in)
Remove the plastic inlet hose (remember to disconnect all the sensors first). This is done by loosening the 2 hoseclips (one each end) that secure it.
Its a tight fit to get out but it will go with a bit of careful juggling.
Now remove the connector to the ECM and with a 1/4" drive with a 10mm socket undo the 4 bolts securing the TCM to the inlet manifold. You'll have to do this by touch but its not hard.
When undoing the last one be careful as its easy to drop it!
Carefully remove the TCM by taking it towards the LHS of the car and then up past the end of the inlet manifold.
Reassembly is the opposite. Be very careful to get the plastic inlet trunking on properly as if yyou don't manifold pressure will just pop it back off again (mine did!).
Should take less than 20 minutes to remove and refit.....
Have fun
Alastair
|
|
* = Field is optional.
+ = Enter space delimited labels for this post. An example entry: 240 muffler
©Jarrod Stenberg 1997-2022. All material except where indicated.
Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.
