Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Torque Specs for Lower Control Arm 850

posted by  MadeInJapan on  Sat Nov 5 15:34 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 2 06:34 CST 2010
[RELATED]

1. The spindle screw that holds the ball joint on is at 50Nm (36.88 lb.-ft.)
2. Tighten the control arm nuts in the sub-frame to 65Nm (47.9 lb-ft) and then angle tighten 120 degrees more . Make sure there is no play after car is lowered. It is important for the bushing life that everything is tight at load. Good luck!

--
1998 S70 T5 Emarald Green Metallic, 2004 V70 2.5T Ruby Red, Previous Owner of Black '94 850 Turbo Wagon. My cars have been running so well lately they've got me worried.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Torque Specs for Lower Control Arm [850]
posted by  1997850  on Sat Nov 5 14:18 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.