Volvo AWD S40-V40 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2014 S40-V40 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing Camshaft position sensor S40-2000 US S40-V40

posted by  sabruzzo on  Sun Dec 24 15:10 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Mar 2 13:49 CST 2007
[RELATED]

Replacing camshaft position (CMP) sensor

Remove:
-relay cover bracket
-connector camshaft position sensor from bracket.


Removing camshaft position (CMP) sensor
-Remove the protective sleeve out of the clamp and open the outer cable protection
-Route the wiring out the protector
-Clean surrounding around sensor
-Remove bolt and move camshaft position (CMP) sensor by turning and take sensor out
-Take cable out clamp.
Note! Note the route of the cable and take it out of the clamp.


Installing camshaft position (CMP) sensor
-Place a new o-ring on the sensor
-Clean housing
-Route the cable via the protective tube and connect the connector at the bracket
-Close the protective tube and install the tube in the clamps
-Place the sensor and tighten the bolt. Tightening torque 10 Nm
-Secure cable in the clamp.


Install
-Connector bracket cover.
Start engine. Read any diagnostic trouble codes (DTCs).






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

Replacing Camshaft position sensor S40-2000 US [S40-V40]
posted by  Andy123  on Sun Dec 24 04:03 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.