Volvo AWD S80 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2007 S80 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: My follow up: S80 2000

posted by  someone claiming to be n0v8or on  Wed Dec 5 09:34 CST 2001 [RELATED]

I made an oversize hole in the bottom cover through which the rubber hose protrudes, and cut the end at an angle similar to the original plastic duct. A possible improvement might be to screw another flat plate to the bottom cover, with a rectangular slot cut in it (could be made of plastic or metal) to force the hose termination into an oval shape, while adding another retention point. Another passibility is to cut off and re-use the fist 2" of the original duct. You will end up with plastic - rubber - plastic, or two rigid sections with a flexible part in between. A couple of hose clamps would hold it all together.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New air intake tube fiasco [S80][2000]
posted by  someone claiming to be PS  on Mon Dec 3 14:38 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.