Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Code 3-2-2 850

Diagnostic trouble code (DTC) information 3–2–2

Condition

Note! (Group II only I)Control Module .
The control module calculates the ratio between the transmission input rpm and the car speed. There is a specific ratio for each gear. If the TCM registers a ratio deviation of more than 10%, the DTC 3–2–2 is set.


Substitute value
Substitution value


Possible source

-Interference with or signal errors on the signal from the transmission rpm sensor
-Interference with or signal errors on the signal from the vehicle speed VS signal from the combined instrument
-Contact resistance in the Solenoid S1 or S2 circuit.
-Gear position sensor incorrectly adjusted
-Malfunction in gear position sensor
-Transmission oil level too low.
-Mechanical fault in the transmission. Worn componenents in the transmission causing slippage or reduced system pressure.


Fault symptom[s]
-Poor performance due to the transmission operating only in 4th gear
-A noise or some obvious mechanical fault is the most common indication of a mechanical fault in the transmission.
--
If you're not driving it "like its stolen," are you really driving?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New transmission problem [850]
posted by  850-j  on Wed Nov 10 06:25 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.