|
I didn't last time I checked, but tomorrow i will check again (too many projects, too little time).
I've already replaced (I should've included this, but was in a hurry when I wrote the original post):
Distributor cap and rotor
Cam-shaft sensor
Plug wires
Plugs
Had injectors cleaned, replaced O-rings and spacers on injectors.
A friend helped me test the injectors to see if they're getting power, and they did (the test light showed it) BUT he wondered if maybe that test wasn't conclusive. So I'm going to buy the IPD injector tester. We get power to the individual injector, just don't know if it's the right amount.
Is there a way to check it via a multimeter? I.E., anyone know what the proper voltage should be?
--
1985 245. 246K Gone..but not forgotten.
|