Volvo AWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Using loctite on a stripped screw

posted by  KlausC on  Sat Jun 18 14:13 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

I may try copper strands first: https://www.youtube.com/watch?v=soOvDuwfnQA

The Loctite is also a very good idea for a slightly better repair.

https://www.youtube.com/watch?v=zUI6GMkTOjU

I will look for the Loctite kit at the local auto parts store or ACE hardware. If I don't find it, then some very long strands of copper wire. The hole is about 1.5 inches deep before the threads start.

Currently, the engine still runs great...

--
Keeping it running is better than buying new






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Using loctite on a stripped screw
posted by  KlausC subscriber  on Thu Jun 9 11:23 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.