Volvo AWD 850 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2006 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

how hard is it to change motor mounts!!!!!! 850 1995

posted by  db on  Thu Jan 10 07:44 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Aug 19 14:50 CST 2010
[RELATED]

IPDusa.com sells a polyurethene mount that is very easy to install (2 half pieces). I opted for the stock rubber one because so many had complained the Poly cause excess vibration--don't know how bad, but some even went back to stock.

Here's how to replace. Cut the old one out by using a hack saw blad and cut through one edge--comes out easy then. Then use a long threaded bolt with 2 metal flanges on both sides and crank it with a nut to press the new one into place (unless you get the Poly, then even easier.

db






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New how hard is it to change motor mounts!!!!!! [850][1995]
posted by  sedan man  on Thu Jan 10 07:11 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.