Volvo AWD 850 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2004 850 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Tips for pipe flange bushing press for upper torque arm? 850 1996

posted by  bru on  Sun Apr 28 08:27 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Dec 1 11:13 CST 2012
[RELATED]

if you still have the old bushing, whith the same interior diameter hole, try shaving/turning the exterior down to slip-fit, then using a rod that just fits the interior diameter: 1. put the old bushing in. 2. install the rod in the old bushing. 3. add the new bushing to the end of the rod, and press in with the old bushing and the rod acting as a guide for the new bushing. You'll obviously need room for the old bushing and rod to fall out of the way when the new one is started.
Rots of ruck.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tips for pipe flange bushing press for upper torque arm? [850][1996]
posted by  daveh  on Sun Apr 28 03:44 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.